POLYETHYLENE FOAM PIPE INSULATION NOMACO - IMCOA - THERMA-CEL
|
|
THERMA-CEL SEAMSEAL / NOMACO NOMALOCK / IMCOA IMCOLOCK POLYETHYLENE PIPE INSULATION WITH SELF SEALING ADHESIVE
DESCRIPTION:
Self-sealing, flexible, polyolefin, thermal insulation and is black in color (Arcticflex is also available and it is white). It is available in wall thicknesses of 3/8”, 1/2”, 3/4” and 1”, in sizes ranging from 3/8” CTS to 4” IPS.
|
APPLICATIONS:
Used to retard heat gain and prevent condensation or frost formation on cold water plumbing, chilledwater and air conditioning lines. Seamseal also retards heat loss on hot water plumbing.
Seamseal has a low thermal conductivity and very low water vapor transmission rate. This low density product demonstrates excellent thermal, physical and chemical resistant properties and has a broad service temperature range between -330°F and 210°F (-201°C and 99°C). It can be installed in commercial, industrial and residential insulation projects. Acceptable for use with heat tracing/heat tape.
INSTALLATION:
Seamseal is pre-slit with factory applied pressure sensitive adhesive (PSA) to both seam surfaces and has convenient built-in release tabs for easy installation: slip on the tube, pull the tab, and pinch it shut. It can be easily pushed around P-traps and fittings, though mitering is recommended for optimum performance. All butt joints should be sealed with 320 or 620 (black) Contact Adhesive or other approved sealing system. It is easily cut with a sharp knife.
Seamseal is available in a wide range of l.D.s and is sized to fit over copper couplings and fittings. It should be installed on pipes that have been pre-tested for leaks, are not presently hot, and have application temperatures that will not exceed 210°F (99°C).
